Base Properties

In this section all base property related information needed to satisfy the Exchange Electrical Model - Systems will be described.

Describes information about the basic electrical properties of an electrical component, flow segment or circuit that is required. Note that electrical base properties should only be applied to an electrical distribution element, an electrical distribution element type or an electrical circuit. However, electrical base properties may also be applied at early design to an element that requires an electrical supply to (for example) a motor but where the motor is not specified as a separate object. An example of this might be where the HVAC engineer could specify power requirement, voltage, phase and frequency for an air handling unit without specifying the fan motor used.
Properties required are as below.

Information Needed	Man	Opt	Rec	Actor Supplying	Functional Part
Type of electrical current applied				Electrical Design	Define Electrical Base Properties (FP)
Input electrical potential				Electrical Design	Define Electrical Base Properties (FP)
Nominal frequency of input voltage wave form				Electrical Design	Define Electrical Base Properties (FP)
Full load electrical current requirements				Electrical Design	Define Electrical Base Properties (FP)
Minimum current carrying capacity of the electrical circuit				Electrical Design	Define Electrical Base Properties (FP)
Maximum power input of the electrical device				Electrical Design	Define Electrical Base Properties (FP)
Actual electrical input power of the electrical device at its rated capacity				Electrical Design	Define Electrical Base Properties (FP)
Relative phase of input conductors				Electrical Design	Define Electrical Base Properties (FP)